Knob-and-tube, cloth-insulated and ungrounded wiring replaced with modern grounded circuits in Ogden — planned around your house, permitted, and warrantied for five years.
Rewiring is the job people put off longest and regret waiting on most. In Ogden it comes up for a specific reason. Ogden has one of the oldest housing stocks on the Wasatch Front. Downtown and the historic districts are full of pre-1950 homes still running 60-amp fuse services, ungrounded two-prong outlets, and the occasional stretch of knob-and-tube in an attic.
Ogden has one of the oldest housing stocks on the Wasatch Front. Downtown and the historic districts are full of pre-1950 homes still running 60-amp fuse services, ungrounded two-prong outlets, and the occasional stretch of knob-and-tube in an attic. Here is what that means on the ground.
Rewiring an older house is a routing problem before it is an electrical one. Where the wire can travel through the structure decides how much finish comes off, and that decides most of the cost. We walk it and plan it before we open anything.
Canyon wind coming out of Ogden Canyon takes lines down more often than people expect, so surge protection and a solid ground are not optional here. We rewire throughout Ogden and Weber County, and we can phase the work so the house stays livable while it happens.
The original wiring method in pre-1950 homes. It has no ground, its insulation embrittles with age, and insurers frequently will not write a policy over it.
Mid-century cloth-covered branch wiring cracks and sheds at the terminations, which is exactly where the heat is. Replacement is the only real fix.
Late-60s and early-70s aluminum branch wiring has known connection failure modes. Remediation ranges from approved connectors to full replacement.
Two-prong outlets throughout a house mean no equipment ground. Modern electronics and appliances assume one is there.
Not everyone can move out. We can rewire a floor, a wing or a circuit group at a time so the house stays livable through it.
Old lath-and-plaster and masonry construction decide the routing. We plan the access before we open anything.
Permits: we pull the Ogden electrical permit where the work requires one and schedule the inspection.
Power company: Rocky Mountain Power serves Ogden. We coordinate the meter disconnect and reconnect for panel and meter work.
Local conditions: Canyon wind coming out of Ogden Canyon takes lines down more often than people expect, so surge protection and a solid ground are not optional here.
You never deal with the city or the utility. That is our job.
We work throughout Ogden and Weber County, including Union Station and Historic 25th Street.
Look in the attic or an unfinished basement for individual wires running through white ceramic tubes and knobs rather than a single cable. If your house predates 1950 and has two-prong outlets, it is worth an inspection either way.
Many carriers will not write or renew a policy on active knob-and-tube, and some ask about aluminum branch wiring specifically. If your carrier has raised it, bring us the letter and we will scope to what they are asking for.
Often not. We can phase the work so you keep a functioning kitchen, bathroom and bedrooms throughout. Whole-house-at-once is faster and usually cheaper per circuit, and we will lay out both options.
Frequently, yes — a rewire is the natural moment to correct an undersized or hazard-brand service, and doing both together costs less than doing them a year apart.
Less than people expect. We fish where we can and cut where we must, and we mark the plan with you before anything opens. Patching can be included in the scope if you want it handled.
Run the numbers yourself with our free EV charger, panel-upgrade, energy and generator calculators. No email required.
Licensed, insured and ready now. Free estimates, upfront pricing, five-year warranty.